Casey . Tool & Die … T10 Tool Steel is a Tungsten alloy steel with a very high carbon content (around 0.9 to 1.0%) with a little bit of silicon (around .35% maximum) and is often referred to as 'High Speed Steel'. Katana - 1566 High Carbon Steel Swords - Asian - Japanese - Katana - 1566 High Carbon Steel Primarily used by Hanwei this high carbon steel has around 0.60 - 0.70 carbon content with a substantial amount of additional manganese (0.85 - 1.15) - this combination creates a deep-hardening steel due to its high degree of hardenability. Katana - 1566 High Carbon Steel Swords - Asian - Japanese - Katana - 1566 High Carbon Steel Primarily used by Hanwei this high carbon steel has around 0.60 - 0.70 carbon content with a substantial amount of additional manganese (0.85 - 1.15) - this combination creates a deep-hardening steel due to its high degree of hardenability. Mechanical Properties of 1060 or 1566 Steel? We use precision ground and case hardened shafting made of 1060 or 1566 steel. Stainless Steel, Special Steel, Compressor Blading, Turbine Blading, Superalloy Supplier. Im having trouble between two swords...which to buy. However, typical case hardened alloys (e.g., 8620, 9310) require carburizing or nitriding to get a hard surface. Contact Suppliers with your enquiries for 1566 any of the shape and size. Katana - 1566 High Carbon Steel Swords - Asian - Japanese - Katana - 1566 High Carbon Steel Primarily used by Hanwei this high carbon steel has around 0.60 - 0.70 carbon content with a substantial amount of additional manganese (0.85 - 1.15) - this combination creates a deep-hardening steel due to its high degree of hardenability. Tool & Die Steels Inc. This deep hardening steel provides a consistent microstructure ensuring a long life and excellent edge holding in demanding applications. I am trying to find the tensile and yield strength of either of these grades. I don t want to list the type of blades or where they are from because ive learned people are very torn and sometimes biased about blades and will say one is better than the other based off of where they are from. Carbon steel is commonly used across many industries. 1566 Steel Composition: 0.6-0.7C 0.85-1.15Mn This deep hardening steel provides a consistent microstructure ensuring a long life and excellent edge holding in demanding applications. Carbon steel is typically composed of 0.05% to about 2.0% carbon measured by weight, along with iron and trace amounts of other elements. If low hardenability sounds a lot like case hardening, it should.